How To Install Ridge Vent For Metal Roofing

You cut z trims for the top of your panels.

How to install ridge vent for metal roofing.

Position a section of metal ridge cap over the peak of the metal roof with the end of the ridge cap flush with one end. To begin the ridge vent installation they measure down 3 inches from the top of the ridge and snap a line to cut the opening for the ridge vent. If you have a vented ridge cap it will require a ridge vent such as profilevent. A ridge vent is an important part of a home s roofing system.

You use your ridge cap to mark the ribs so that you know where to place the z trims. Pull off the paper backing from the face of an adhesive closure strip cut to match the. For most asphalt shingle ridge caps there are two. Ensure that there is a 2 inch wide opening at the ridge for ventilation.

Install the ridge vent shingle over style install the ridge vent aluminum. Install profilevent to 1 up slope from the edge of the ridge cap. Start from the end of the ridge and start rolling out the ridge vent along the length of both sides of the ridge cap. Install the ridge cap.

We use a z trim and make sure to have tape seal underneath the z trim and between the ridge cap and the top of the z. Start by removing the nails holding the ridge cap shingles in place. Flashing is metal trim that fits over joints where two sections of roof meet. If you would like more information on.

Bend the flashing into a v shape to fit over the top roof ridge and the corners where the panels meet. This is needed for proper installation. How to install ridge cap vent for a metal roof for a vented ridge cap there needs to be a 2 inch wide opening at the ridge for ventilation. Installed at the peak of a sloped roof the ridge vent allows damp warm air to escape from the attic.

Below we ve compiled some helpful tips on how to install a ridge vent for metal roofing. It helps direct water away from the. The flashing should overlap the edge of the roof by one inch to help direct. Remove the shingle caps.

Cut the ventilation opening. Using a circular saw with a carbide tip blade one of the roofers plunges the saw into the ridge at the ends and then follows the chalk line.