How To Install Standing Seam Siding

Snap the panels together and fasten along the opposite side and top of the panel.

How to install standing seam siding.

Snap first two to three inches of panel together and slide the panel tight against the eave trim or with the gap depending on the temperature. When used extended drip edge should be installed first along the drip edge of the roof. Standing seam integrated thin film solar panels. Installing standing seam metal panels.

Place sealant over underlap rib before sliding hem over the eave trim. Standing seam consists of sheet metal roofing panels joined side by side and attached to the roofing. Pancake screws are applied to the nail strip of the standing seam panels. Install endwall flashing onto zee closures by riveting flashing to top flange of zees at 18 inches on center onto top flange of zee.

Unisolar pv panels 136 w 216 each http amzn to 29gz5mt learn how to install metal roof in 15 m. The lower end of each panel is then trimmed and the hem pre bent before installation see pg 9. An alternate technique is to hem the rake edge which is shown in one of our other vide. Fasten with appropriate substrate fastener at minimum 4 fasteners per zee or 3 inches on center.

Apply row of tube sealant along back face of zee closure adjacent to panel legs. There are many different types of metal roofing systems but standing seam is becoming the metal roofing system of choice when it comes commercial industrial and many residential metal roofing projects.