By using a vinyl siding removal tool you can guide loose panels back into place.
How to reattach a loose piece of vinyl siding.
Once you locate all areas of looseness begin snapping the loose edge back into place against the locking ridge.
How to retack siding.
Repair loose vinyl siding panels as soon as possible to avoid insect infestation or damage to your home due to wind rain or cold temperatures.
First remove the corner piece then slide the zip tool under the siding and loosen it up.
Be sure to leave about 1 8 of the nail exposed to allow the siding to flex.
Under normal circumstances vinyl siding should not come loose if it was originally hung properly.
Remove the siding in the reverse of how it was installed.
Use it to grab the locking edge of the loose panel and pull downward.
This can cause panels to chip or crack if left unattended.
Work down the panel using your hand and the siding tool in this way until the panel has completely snapped back together.
This process lets you find the full extent of the disconnection between pieces.
Cut a vinyl patch 4 inches 10 cm wider than the removed segment.
Do apply too much pressure when lifing vinyl panels as these panels can chip or crack.
Gently pull with the tool as you move along the loose piece.
Cut the spare piece of vinyl along the marks using straight tin snips.
Be careful because older siding can become brittle.
Hgtv expert henry harrison shows how you can reattach it using a vinyl siding removal tool also known as a zip tool.
Measure and mark a point 2 inches 5 1 cm away from each side of the removed segment.
At the same time use your hand to push the panel onto the upper locking edge of the panel beneath it.
The panels should reattach easily.
Over time vinyl siding panels can become loose.
Diy how to fix loose vinyl siding with a malco sideswiper siding tool.
Vinyl siding is installed from the bottom up.
You may want to wait for a warm day when the siding will be softer and more pliable.
After you get the siding loosened reattach the corner piece.
If rotten wood.
Fit the siding removal tool underneath the lower edge of the loose siding piece.
Insert the hook of a vinyl siding removal tool into the buttlock of a panel you want to snap back in place.
