How to install step flashing under siding.
How to remove siding install flashing.
Use an old rag to remove any dirt or debris that may be there.
Use a zip tool to disconnect two pieces of siding.
Fold the roof side of the.
Cut the drip cap to the correct size for your window.
Avoid using galvanized flashing with acq treated lumber because it can cause corrosion.
Next slide drip flashing behind the vinyl so the lip fits over the top of the ledger as shown at right.
To remove a piece at your eye level slide the zip tool under the piece above that one.
Using a pry bar you will need to remove a layer of siding from above the window you want to install the drip cap on.
Zip tools disconnect a higher piece from a lower piece.
Step flashings are quite often improperly installed on the exterior of siding.
A the flashing was not properly installed.
Install undersill trim along the edge of the vinyl over the flashing at the top and bottom.
The type and location of the flashings will vary depending on the type of windows and doors.
If you have vinyl or metal flanged windows for instance you can install drip cap flashing 4 the home depot over the window itself or over the top trim piece that you install.
Use roofing nails to install the l shaped flashing flush with the roof and wall then cover it with roofing cement and reattach the roofer s felt.
Add felt if needed before nailing the new wood on and prime the new wood on all four sides before installing it.
Install the kickout flashing underneath the first shingle photo 1.
Then tack the ledger into place with 16d nails.
Attach the flashing tape above the window and then slip the drip cap into the siding and attach to the tape.
Lay a shingle over the step flashing starting at the roof edge.
Failing to install step flashing behind siding.
Slice along the bend line about 4 inches into the first piece of flashing at the bottom of the roof with tin snips.
However in most instances step flashing should be installed behind siding.
In other words you will have to rip off the.
Then nail the new l shaped flashing under the builder s felt but above the fascia board.
For a wood window unit drip cap flashing can be installed over the trim piece often called brick molding that comes.
Begin by removing the shingles at the affected area and removing old flashing if present.
Reveal the nails anchoring a piece to the wall by sticking the zip tool under the bottom of the piece above it.
In certain instances flashing may need to be installed on the exterior of siding.
Fasten that shingle with two galvanized.
