How To Replace A Piece Of Hardiplank Siding

Do not drive the nails flush or countersink them.

How to replace a piece of hardiplank siding.

The best way to fix these gaps is to clean the joint and then patch it with caulk. Use a pry bar to remove the damaged siding. How to remove hardie plank step 1. Placing the new piece of hardie board is just as simple as the demo.

Score down the damaged lap siding with a utility knife. Remove the nails in the corner cap. Prime the back and edges of the new siding. Fiber cement siding removal procedures to minimize dust to permit possible salvage re use of the material.

Pry the piece of siding out toward you gently to let you see the nail or screw patterning of how the planks have. Trim your replacement pieces down to size using the old siding for reference. Thoroughly paint all exposed edges and grooves. Face nail the top.

Then use a chalk line to create a reference mark for the first or bottom piece of siding and start securing the siding pieces from the bottom to the top. Remove any nails from the top piece of good siding. Placing your hardie board. Blind nail the fiber cement siding in place starting with the bottom piece.

The article details just how the old fiber cement siding was removed with minimum damage. This way water and other elements can t go past the patch between or behind the planks and cause further damage. Remove any nails that still might be underneath the bottom portion of the piece above the one you removed. Remove the nails on the lap board then use the claw of the hammer to split the board down the center image 1.

Just the nails that will prevent the new board from sliding back into place you can either completely remove the nails or clip them off. This article describes why owners decided to remove fiber cement siding from their home and to replace it with james hardie s hardieplank fiber cement product. To remove and replace damaged siding. A long piece of siding will sag in the middle so use temporary blocks to hold it in place while you attach it.

Once all the nails are removed from the adjoining board the damaged one should just pull out. Cut the fiber cement siding to length wear approved dust protection. When siding shrinks it causes a gap to form between the planks. The heads will break the paper face allowing water to soak in and deteriorate the siding.