How To Replace An Awning Motor

We carefully unfolded located front and back and slid the new rv awning with the attached polly cord into the awning roller.

How to replace an awning motor.

Install the motor by sliding it all the way into the end of the roller tube. The steps to replace the rv awning are almost the opposite of the removal. We then secured the polly cord with screws to the roller. Remove the cap spring.

Loosen the bolts holding it in place and lift it out of the housing. Refer to the owner s manual as the parts included can be slightly different from manufacture to manufacturer. Tie the awning arms off to the bracket where it attaches to the side of your rv. Use the manual override if the motor is completely.

Replacing the motor on a solara power awning extend your awning about 2 feet. Do this on both ends. If you thought replacing your rv s main patio awning was out of your league as a do it yourselfer watch this first and you just might change your mind. Purchase a replacement awning fabric.

Reinstall the gear for the manual handle. Loosen the awning bolts. New motor and wind sensor. If this is the case unplug the motor from the electrical source.

Use high quality heavyweight tight weave vinyl for the best results. To do so measure from the center of one arm to the. This will give you room to work. Measure for the correct awning replacement fabric.

Check the manufacturer s instructions for fabric recommendations. Unbolt the chain from the drive shaft of the awning motor. Install a new motor and tighten the bolts. Attach the hardware one by one.

How to replace rv awning fabric. Choose a fabric replacement. Start by measuring your awning from the inside of each cap.