How To Replace Electric Awning Motor

This should be done in a retracted position.

How to replace electric awning motor.

Remove the awning from the mounting bracket and lay it safely on the ground. Free shipping by amazon. Carefree r001326wht white rv travel r electric awning replacement motor. Remove the connection and test the voltage at that point.

Solera awning motor wires remove the 3 bolts that hold the motor in place using a 10mm wrench or socket. Best seller in patio awnings. Install a new motor and tighten the bolts. 4 6 out of 5 stars 34.

You may have to rotate the motor slightly to get the gears to line up and then rotate it back in place to line up the bolt holes. Loosen the roller end bracket securing bolts and remove the bracket from the torsion bar by sliding it to the left end of the bar. Aecojoy 10 8 patio awning retractable sun shade awning cover outdoor patio canopy sunsetter deck awnings with manual crank handle beige. You will possibility need two ladders.

You have to connect back the wiring connection at the awing wiring and coach wiring before you do this step otherwise you wont have the voltage. Cover the upper awning brackets with electrical tape or masking tape. Connect the chain for the awning and plug into the electrical supply. Loosen the bolts holding it in place and lift it out of the housing.

Drill out the rivets holding the end of the cap on the end of the roller. With the solera power awning replacement motor your awning will be operating as usual in no time. Replace electric awning fabric. Pull out the motor unplug the wire plug in the new motor and reverse everything.

You will need pop rivets reinstall the end cap. This will make sure they don t scratch the side of the rv. Unbolt the chain from the drive shaft of the awning motor. If your awning is really old use a sharp edge to cut away the sealant that connects the fabric to the track.

After your awning is safely on the ground remove the end cap. Remove the bad motor and replace it with the new one. Unscrew the panel box and access the point where it makes the connection. Be sure to apply tape before sliding the awning off the rv.