Be sure that the hem of the fabric is facing down.
How to replace sunsetter awning fabric.
Insert new awning fabric into channels you marked.
Hold the front bar and loosen the left front bar insert with a 5mm allen wrench and pull the insert out of the front bar.
Insert the cut end of the cord into the fabric slot on the roller bar and the other end of the fabric into the awning rail.
Phillips screwdriver figure 3 t bar end plate awning fabric alance 3.
For awnings that have a sunsetter aluminum hood installed remove the hood end plate on the opposite side of the motor or gear assembly.
Remove the front bar from the fabric and place aside for reuse later in reassembly.
Insert the new valances into the front bars until they stop at the other end.
Tuck the ends of the fabric into the channels that you marked and ensure that it is centered.
While keeping the fabric reasonably stretched on the roller bar turn the crank wand counter clockwise to slowly roll the fabric onto the roller bar.
Using the manual crank wand continue to unroll the fabric until you expose the fabric slot in the roller bar.
Also make sure that the valance is in the channel you marked with a v.
Slide the fabric onto the roller bar and awning rail at the same time until approximately 6 is still extending out of the roller bar on the left side.
Locate the replacement valances and trim the gray cord to a length of inch on each end.