Just be sure they re positioned high up under the shingles.
How to secure roofing material to drip strip.
You need drip strip.
Once free slide the drip edge out and discard.
It will stop water from going between the facia board and back side of the.
If necessary secure the ends of the drip edge with short roofing nails.
Drip strip comes in 8 foot lengths in white or musket brown and can be ordered from your local erie materials branch.
To install drip strip it is simple.
It can be done.
Dip a 2 inch wide brush into the cement and lay a 2 inch line of cement from end to end of the.
Aluminum or stainless trim nails are fine.
Use a roofing nail 1 to tack the drip edge down one every 10 when placing two pieces of drip edge together overlap one end over the other by 1 and secure using two roofing nails one in the back and one in the front.
Both raw material and finished product is made in the usa.
Secure the drip edge with roofing cement.
Ensure that you hammer the nails properly into the roof don t leave the nails sticking up above the layer.
Neg s new drip strip installs easily behind the drip edge to prevent water and ice from getting behind the gutter and harming the fascia board.
Open a can of roofing cement.
If there isn t enough room then you could go through the drip edge.
Make sure when driving the nails you also flatten the flashing as flat as possible.
I recommend using 1 trim nail in the center and one on every overlap of the ends.
Hammer the nails in at 10 inches 25 cm intervals across the roof.
Hammer nails into the rolled roofing to secure it.
Apply a continuous bead of cement along the top of the drip edge then press down on the shingle.
Make sure you use a strong hammer and 1 inch 2 5 cm roofing nails.
This is an asphalt based glue that will adhere to almost anything.
Atlantic drain do you have water running behind the gutter.
Let me know if you need anything else.
If you have enough room i would suggest nailing trough the drip strip into the fascia below the drip edge.
You can also use.
Gently lift up the shingles on the edge of the roof and locate the nails holding the existing drip edge onto.
Remove the drip edge and apply a thin strip of roofing cement at the top edge above the line you marked and slide the drip edge back under the shingles to the mark you made.
