Ankame temporary roof anchor.
How to use roof anchor.
When using a roof anchor points system it is a legal requirement to establish emergency and rescue procedures.
Don t work more than 4 ft.
The rescue plan must have been tested to ensure that it is effective.
What could render your roof anchor point unsafe for use.
If a roof anchor point has not been certified in the previous 12 months it should not be used as it may not be in good working order.
Falls from heights kill approximately 26 workers and injure another 7 700 each year in australia.
The applicable standard prescribes.
Mount the roof anchor to the peak no closer than 6 ft.
Anchor points are usually installed on the roof and are used to connect lanyards lifelines and other forms of tie off which prevent a worker from falling.
Of course this is quite difficult to measure.
Locate the roof anchor directly above where you ll be working on the roof.
An anchor point should be able to hold a force of 10 kn for as long as 3 minutes.
If you or your employees are required to work at heights having the right roof anchor points is essential to prevent fall fatalities.
Using a fixed anchor point.
For that reason three of the most common methods to create an anchor point for work on a sloping roof are outlined below.
To the side of the roof anchor.
Why you need roof anchor points when working at heights.
From the edge of the roof.
Using a jamb anchor.
Roof anchors can be as simple as a d ring connection or as complex as a complete lifeline system.
Situated right on the front of the box is the following statement to be installed and used by competent persons only.
Relocate the anchor or add more anchors if necessary.
Working at heights is fraught with danger.
Both permanent and temporary roof anchor points are available.