Snap a level chalk line for the first starter strip at the base of the wall no less than 8 inches above ground level after determining the lowest corner of the house.
How to vinyl siding starter strip.
The bottom of the starter strip the part the bottom panel hooks on to should be at least.
Cut the new starter strip to size.
Vinyl siding is no exception.
When correctly installed certified vinyl siding will al.
How to install a vinyl siding starter strip step 1.
Pry off the nails on the nailing flange with a claw hammer to remove the starter strip.
Staret strip secures the first course of siding to the home.
How to replace starter strips for vinyl siding 1.
Insert the flat hooked end of the zip tool under the lip on the bottom most edge of the vinyl siding panel that rests.
Make a mark on the wall and record the measurement.
Tahomamaintenanceco march 23 2018 10 58pm 5.
Measure a spot that is 1 1 2 inches above the bottom edge of the sheathing at this lowest point using a tape.
Vinyl siding starter strips.
This video shows how to install a starter strip for vinyl and polymer siding installation.
Mice bees and all sorts of other critters love making their home inside vinyl corner posts.
Optional method to determining the position of the starter strip in new construction and some re siding applications.
Measure down from the soffit at one corner of the house to the top of the foundation and subtract 1 4 6 4mm less than the width of the starter strip.
Secure the end to the house and set the starterstrips against this mark.
Hold a tape measure against the exterior wall and travel.
This is where the new siding will begin.
Quality products can only perform well if they are installed properly.
Cap the corner posts.
When the wall surface is uneven shim out the starter strip to avoid a wavy appearance in the finished siding job.
Attach one end of the string to the corner of the wall you wish to install a starter strip next hook on the hanging level and walk the string to the other corner now observe the level and adjust the string until it s level.
Locate the lowest possible corner that has sheathing.
Pull up as.
Nail to wall following nailing instructions in important installation tips.