Improving Burn Spot On Carpet

Cut the carpet strands as long as possible so they can be attached and hide the burnt area.

Improving burn spot on carpet.

Then using a pair of tweezers or similar grab the strands you just cut with the tweezers and put them in the burn hole. Now apply the superglue in a very small amount to the bottom of the burn hole. Try to only cut the black or brown burnt part not the lower unaffected layer. Begin by sanding away burn marks with sandpaper.

This method is only suitable for small burns such as those cause by a cigarette. Step 1 loosen up the fibers with a pair of tweezers. Cut a few fibers from an area of the carpet that. Remove remaining black fibers by cutting them out with scissors.

Comb the area with a wide toothed comb to restore the fibers and blend the area in with the other carpet. Go slowly and be patient as the carpet might be difficult. You want the carpet fibers to stand up as straight as possible which will make it easier to target the burnt pieces. Use the tweezers to brush the fibers back against the grain plucking at them a bit to loosen them up 2 x research sourcestep 2 snip off the burnt top layer with a pair of scissors.

Cut away the burned carpet fibers using a sharp pair of scissors. You ll also want to cut through the carpet below it. Using a utility knife cut around the edges. Cut some carpet fibers near a wall inside a cupboard or from a cut off where it won t be noticeable.

Place the new piece of carpet over the burned area. Vacuum any debris away.